Re: Loading WEP Modules...Unresolved Symbols

From: Jason Boxman (
Date: 2002-08-29 16:17:45 UTC

On Thursday 29 August 2002 08:56 am, Ted Phelps wrote:
> "Ryan Abbenhuys" may have said:
> > Could you perhaps step me through the installation process. For some
> > reason time and time again I keep getting Unresolved Symbols in the 3
> > modules mentioned below. Even when I start on a completely new Redhat
> > system with a fresh installation.
> I had a similar problem, which might be related to what you're seeing.
> When I insert the card, cardmgr tries to load the hostap_cs module
> using modprobe. If that fails it falls back to using insmod, which
> won't work because it won't get the module dependencies, leaving you
> with a huge stack of unresolved symbols.
> Last time I checked, the parameters were as follows:
> hostap_cs.o: irq_mask, irq_list, ignore_cis_vcc, mtu, channel, essid,
> iw_mode, beacon_int, dtim_period, delay_enabled,
> disable_on_close, bus_master_threshold_rx and
> bus_master_threshold_tx
> hostap.o: other_ap_policy, ap_max_inactivity, ap_bridge_packets,
> autom_ap_wds

That'd be useful in documentation, since I didn't even know about those. :)

> Hope this helps...
> Cheers,
> -Ted


Jason Boxman
Administrator TrekWeb.COM - Linux Pages

This archive was generated by hypermail 2.1.4.