Re: plx card problem, dmesg and messages


From: Zbynek Jun (konfery_at_interchemia.cz)
Date: 2002-09-18 07:13:55 UTC



The same otuput(last 10 lines) i get if i try to softupgrade PRI firmware in my xi-325h...

> sorry for late reply, but I have been quite busy recently...
>
> > That dmesg output did not include any messages from Host AP driver.
> > Please run 'dmesg' after having tried to load hostap_plx.o module (i.e.,
> > I'm interested in the debug messages that the Host AP driver logs during
> > initialization).
>
> hostap_crypt: registered algorithm 'NULL'
> hostap_plx: hostap_plx.c 0.0.0 2002-09-12 (SSH Communications Security
Corp,
> Jouni Malinen)
> hostap_plx: (c) Jouni Malinen <jkmaline_at_cc.hut.fi>
> PCI: Found IRQ 5 for device 00:09.0
> PLX9052 PCI/PCMCIA adapter: mem=0xd9000000, plx_io=0x0, irq=5,
> pccard_io=0xdc00
> hostap_plx: CIS: 01 03 00 00 ff 17 ...
> hostap_plx: manfid=0x0156, 0x0002
> hostap_plx: cor_index=0x1 cor_offset=0x3e0
> Prism2/2.5 PC Card detected in PLX9052 adapter
> PLX_INTCSR=0xffffffff
> PLX_CNTRL=0xffffffff (Serial EEPROM present=1)
> hostap_plx: Registered netdevice wlan0
> prism2_hw_init()
> prism2_hw_config: initialized in 8300 iterations
> Could not get RID for component NIC
> wlan0: PRI: id=0x15 v0.3.0
> wlan0: STA: id=0x1f v0.7.6
> wlan0: hfa384x_get_rid - RID len mismatch: rid=0xfdc1, len=8 (expected 2)
> wlan0: hfa384x_get_rid - RID len mismatch: rid=0xfc01, len=34 (expected 6)
> wlan0: could not get own MAC address
> wlan0: hfa384x_get_rid - RID len mismatch: rid=0xfc84, len=4 (expected 2)
> wlan0: hfa384x_get_rid - RID len mismatch: rid=0xfc83, len=36 (expected 2)
> wlan0: hfa384x_get_rid - RID len mismatch: rid=0xfc82, len=4 (expected 2)
> wlan0: Channel list read failed
> wlan0: LinkStatus=2 (Disconnected)
>



This archive was generated by hypermail 2.1.4.