From: Jason Price (wireless_at_inetica.com)
Date: 2002-09-11 16:53:31 UTC
sorry should read.. linksys wmp11
> I have a wmp11 upgraded to the new firmware.. everthing seems to be setup
> correctly:
>
> wlan0 IEEE 802.11-DS ESSID:"test"
> Mode:Master Frequency:2.422GHz Access Point: 00:06:25:03:54:1C
> Bit Rate:2Mb/s Tx-Power:-10 dBm Sensitivity=1/3
> Retry min limit:8 RTS thr:off Fragment thr:off
> Encryption key:off
> Power Management:off
> Link Quality:0 Signal level:0 Noise level:0
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
> -
> Here is the issue, when ever i look at the sig. ie with netstumbler.. it
> comes up for 1 or 2 sec and the dies off for another min or so. its enough
> for winblows xp to see the ap , and connect but you cant transmit data. i
> ran netstumbler for a extended period of time and you could only see the
> wmp11 about once every 30 sec. i remember having this problem with a dlink
> dwl-650 card ( on another system )but after i switched to a netgear it
went
> away. any idea what the deal is ?
>
> hostap_pci: Netdevice wlan0 unregistered
> hostap_pci: Driver unloaded
> hostap_pci: hostap_pci.c 0.0.0 2002-05-19 (SSH Communications Security
Corp,
> Jouni Malinen)
> hostap_pci: (c) SSH Communications Security Corp <jkm_at_ssh.com>
> hostap_pci: Registered netdevice wlan0
> prism2_hw_init()
> prism2_hw_config: initialized in 18131 iterations
> wlan0: NIC: id=0x8013 v1.0.0
> wlan0: PRI: id=0x15 v1.1.0
> wlan0: STA: id=0x1f v1.4.9
> wlan0: Intersil Prism2.5 PCI: mem=0xf0000000, irq=10
> wlan0: prism2_open
>
>