frame capture, DWL900AP Point to Point link

From: Jason Boxman (jasonb_at_edseek.com)
Date: 2002-09-05 02:31:48 UTC

• Next message: Ka Chun, Cheng: "Re: plx card problem"
• Previous message: Jason Boxman: "Re: plx card problem"
• Next in thread: Jouni Malinen: "Re: frame capture, DWL900AP Point to Point link"
• Reply: Jouni Malinen: "Re: frame capture, DWL900AP Point to Point link"
• Reply: Xam R. Time: "Re: frame capture, DWL900AP Point to Point link"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

A while ago someone mentioned support could be added for talking to a D-Link DWL900AP running in Point to Point mode if captures were provided, so here some are. If someone could tell me what's going on between these two APs, that would be educational as well.

The setup is two D-Link DWL900APs (non plus) on channel 7 in Point to Point mode. Frames were captured with a LinkSys WPC11 Prism2 based card using HostAP from yesterday's CVS in monitor mode 2 with tethereal and CVS of libpcap.

(Attached, gzip'd.)

-- 

Jason Boxman
Administrator TrekWeb.COM
http://trekweb.com/~jasonb/articles/ - Linux Pages




application/x-gzip attachment: dwl900ap.out.gz

• Next message: Ka Chun, Cheng: "Re: plx card problem"
• Previous message: Jason Boxman: "Re: plx card problem"
• Next in thread: Jouni Malinen: "Re: frame capture, DWL900AP Point to Point link"
• Reply: Jouni Malinen: "Re: frame capture, DWL900AP Point to Point link"
• Reply: Xam R. Time: "Re: frame capture, DWL900AP Point to Point link"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]