WLAN0 and ETH0

From: S.M. (sm960215_at_po.jah.ne.jp)
Date: 2002-02-18 19:25:32 UTC

• Next message: Howard Leaky: "Progress on WEP in HostAP mode?"
• Previous message: Adam Shand: "Re: tx power ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hello,

MY name is Seiichiro, writing from Tokyo/Japan. I found the HostAP driver in this project works fairly well, but I happened to have one serious problem.

As some says in previous mail...

> want to setup a bridge between my wired network and the
>wireless one for use with one wireless machine.
>At the moment if I create the bridge with eth0 and wlan0
>I can still connect via the wired lan but cannot
>ping from the wireless lan

I am experiencing the same problem with the following environment.

	Linux kernel 2.4.9
	PCMCIA-CS0-3.1.30
	Prism2 driver from this HP (Feb.13.2002)
	Ethernet   RealTeck 100BaseT
	IRQ assigned by BIOS   IRQ 5 shared (wlan ether)	

I am using a desktop PC with Richo CardBus-PCI bridge card, and PrismII based (Corega.K.K.) card. Wlan itself works fine with HostAP mode.

Any experience or advice will be helpfull for me. Many Thanks !!

Seiichiro

• Next message: Howard Leaky: "Progress on WEP in HostAP mode?"
• Previous message: Adam Shand: "Re: tx power ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]