getting hostap_cs back after having wlan-ng installed

From: Yael Shavit (yael_at_wavion.biz)
Date: 2002-09-01 13:37:34 UTC

• Next message: Jason Boxman: "Re: Problem with Channel 13"
• Previous message: Paul Hedderly: "Re: [lwlan-user] Actiontec USB adaptor "prism2sta_probe_usb: prism2_usb: wlan_setup() failed""
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hi,

The linux machine I have used to have the hostap_cs installed for monitoring purposes.

For some reason, the WLAN NIC ("BroMax Freeport 11Mbps 802.11b WLAN Card (Prism2.5)") was changed to connect the linux to a regular Intersil AP. The machine boots with the command "cardmgr[764]: executing: 'modprobe prism_cs' " which loads the wlan-ng and not the hostap.

Now I wish to get the hostap back again. The kernel is compiled with the hostap, but I failed to get it to the cardmgr command. i.e. I would like to get the cardmgr to execute the command 'modprobe hostap_cs' but I fail. Please advice.

Thanks,

Yael

Yael Shavit             Tel:  +972-4-9097359
Networking             Fax: +972-4-9594122
Wavion Ltd.            Email: yael_at_wavion.biz
       http://www.wavion.biz


        

• Next message: Jason Boxman: "Re: Problem with Channel 13"
• Previous message: Paul Hedderly: "Re: [lwlan-user] Actiontec USB adaptor "prism2sta_probe_usb: prism2_usb: wlan_setup() failed""
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
• Mail actions: [ respond to this message ] [ mail a new topic ]