Re: Anyone get an Intel 2011B PCI adapter to work?

From: Jouni Malinen (
Date: 2002-08-13 15:10:16 UTC

On Thu, Aug 08, 2002 at 01:45:01PM -0600, Michael Milligan wrote:

> prism2_hw_config: initialized in 17312 iterations
> wlan0: NIC: id=0x8013 v1.0.0
> wlan0: PRI: id=0x15 v1.0.7
> wlan0: STA: id=0x1f v1.3.5

OK.. that should work.

> Setting ALC off
> Setting TX power to 15 dBm

Have you tested without setting the TX power (i.e., using the default and let the firmware decide the power level)? If that does not work, what about running 'iwpriv wlan0 reset 2' after everything is setup (i.e., resetting port0 again)?

> I read that in the FAQ and wasn't worried since this has v1.3.5. But, I'm
> going to play around with RAM download support to try a couple different
> station firmware versions and see if anything changes.

Yes, 1.3.5 should work. It works fine in my test setup and I haven't heard any reports of problems with it and Host AP mode.

Jouni Malinen                                            PGP id EFC895FA

This archive was generated by hypermail 2.1.4.