aboutsummaryrefslogtreecommitdiffstats
Commit message (Expand)AuthorAgeFilesLines
* Fix writing of wpa_supplicant sae_groups configuration parameterJouni Malinen2017-01-071-1/+1
* Send BEACON-REQ-TX-STATUS event only for beacon reportsJouni Malinen2017-01-071-2/+8
* tests: LCI report generation and os_get_reltime() failureJouni Malinen2017-01-071-0/+15
* tests: TEST_FAIL() support for os_get_random()Jouni Malinen2017-01-071-0/+3
* RRM: Use wpa_hexdump_buf() instead of wpa_hexdump()Jouni Malinen2017-01-071-2/+1
* tests: Radio measurement request - link measurementJouni Malinen2017-01-071-0/+48
* nl80211: Register for Link Measurement Report frames in AP modeJouni Malinen2017-01-071-0/+3
* RRM: Document Link Measurement Report frame construction stepsJouni Malinen2017-01-071-1/+5
* tests: Radio/link measurement request for non-RRM associationJouni Malinen2017-01-071-0/+29
* tests: Radio measurement request - OOM while rejecting a requestJouni Malinen2017-01-071-0/+23
* tests: Fix rrm_beacon_req_passive_ap_channels to use passive scanJouni Malinen2017-01-071-1/+1
* tests: Beacon request - active scan mode os_get_random failureJouni Malinen2017-01-071-0/+16
* tests: Check rrm capabilities with a helper functionJouni Malinen2017-01-071-39/+22
* tests: Remove write-only bssid assignments from rrm test casesJouni Malinen2017-01-071-13/+0
* tests: Beacon request - passive scan mode - VHTJouni Malinen2017-01-071-0/+102
* RRM: Fix beacon report scan channels for VHT 80, 80+80, 160 MHz casesJouni Malinen2017-01-071-0/+6
* RRM: Move wpabuf_resize() call into wpas_rrm_report_elem()Jouni Malinen2017-01-071-42/+15
* tests: Prepare rrm_beacon_req_passive_no_match_oom for code changeJouni Malinen2017-01-071-1/+1
* RRM: Remove unnecessary cb checkJouni Malinen2017-01-071-6/+0
* AP: Skip authentication/deauthentication phase for DMG/IEEE 802.11adDedy Lansky2017-01-053-29/+109
* AP: Do not look for supported rates in DMG/IEEE 802.11adDedy Lansky2017-01-051-0/+5
* bgscan_simple: Fix short_scan_count comparisonBeni Lev2017-01-051-6/+1
* nl80211: Zero num_modes if nl80211_get_hw_feature_data() failsAndrei Otcheretianski2017-01-051-0/+1
* tests: P2P autonomous GO switching channels (separate group interface)Jouni Malinen2017-01-051-1/+12
* tests: Use group control interface for GO commands in autogo_chan_switchAvraham Stern2017-01-051-2/+2
* nl80211: Use correct attribute for scan flags in vendor scanKanchanapally, Vidyullatha2017-01-051-1/+1
* eap_proxy: On SIM error flush PMKSAs only for SIM/AKA/AKA' networksPurushottam Kushwaha2017-01-041-1/+29
* tests: Beacon request - active scan mode and old scan resultJouni Malinen2017-01-031-0/+27
* tests: Beacon request - passive scan mode and no matching BSSJouni Malinen2017-01-031-0/+40
* tests: Beacon request - active scan mode and many BSSsJouni Malinen2017-01-035-0/+87
* tests: LCI report generation OOMJouni Malinen2017-01-031-0/+25
* tests: wpa_supplicant and concurrent NEIGHBOR_REP_REQUEST commandsJouni Malinen2017-01-031-0/+25
* tests: NEIGHBOR_REP_REQUEST for AP not supporting neighbor reportJouni Malinen2017-01-031-0/+16
* tests: wpa_supplicant and disconnection during NEIGHBOR_REP_REQUESTJouni Malinen2017-01-031-0/+27
* tests: wpa_supplicant ctrl_iface NEIGHBOR_REP_REQUEST OOMJouni Malinen2017-01-031-0/+29
* Fix OOM handling in neighbor report response handlingJouni Malinen2017-01-031-1/+3
* tests: wpa_supplicant behavior on NEIGHBOR_REP_REQUEST response timeoutJouni Malinen2017-01-031-0/+23
* tests: Radio measurement request - protocol testingJouni Malinen2017-01-031-0/+97
* Allow LCI request with no subelementsJouni Malinen2017-01-031-1/+2
* tests: RRM beacon report with active and passive scanJouni Malinen2017-01-031-0/+215
* RRM: Enable beacon report with active/passive scan for all driversJouni Malinen2017-01-035-13/+75
* tests: Beacon request - beacon table modeJouni Malinen2017-01-031-1/+445
* Report received beacon report with BEACON-RESP-RX eventJouni Malinen2017-01-032-3/+32
* Report beacon request TX status as control interface eventJouni Malinen2017-01-034-2/+46
* Beacon request through hostapd control interfaceJouni Malinen2017-01-034-0/+142
* Add hostapd configuration parameter rrm_beacon_reportJouni Malinen2017-01-032-0/+9
* Enable Beacon Report using beacon table for all driversJouni Malinen2017-01-032-5/+7
* Update copyright notices for the new year 2017Jouni Malinen2017-01-0318-27/+27
* Do not add own BSS in neighbor report with invalid op_class/channelJouni Malinen2017-01-031-4/+6
* FILS: Fix FILS Realm Information ANQP-element constructionJouni Malinen2017-01-031-0/+1